EP Specifications


Range consists of 5 customizable models.

  • For room temperatures down to –5 °C the electric defrost version is advisable, whereas for lower temperatures (≥ –12 °C) an additional electric heater in the drip tray is recommended

On request, the models can be equipped with non-standard: coils, defrosting, and fan motors.

Coil Features
  • The entire EP range is equipped with high efficiency coils suitable for new generation refrigerants made from special profile aluminium fins and inner grooved copper tube(smooth tube for brine coolers)
  • Dual fin spacing 3,5/7 mm
  • The updated coil design responds to the recent guidelines governing the reduction of HFC gases with high greenhouse effect
Casing Features Made of a magnesium aluminum alloy, with a smooth finish covered by a plastic protection film
Fan Motors
The standard AC fan motors employed have the following features:
  • Ø 230 mm
  • fan motor module: from 1 to 3
  • single-phase 230V/1/50-60 Hz
  • fibreglass charged polyamide fan guard

The optional high efficiency EC fan motors have the following features:
  • Ø 200 mm
  • fan motor module: the same as AC fan motors
  • single-phase 230V/1/50-60Hz
  • fibreglass charged polyamide fan guard
The versions with standard electric defrost (ED) are equipped with stainless steel heaters with vulcanised terminals preset for 230V/1/50-60Hz connection
The fan motors and the electric heaters of the EP/B models are prewired in IP 54 junction boxes
  • CE
  • PED
Published Data
  • EN 328 reference standard
  • Nominal capacity assessed in practical operating ambient i.e. in wet conditions
  • R448A refrigerant (media glide)
    • air inlet temperature 0 °C)
    • evaporating temperature –8 °C
    • TD 8 K

Contact Modine For More Information